Toshiba MJ-1104, MJ-1103 Exit sensor S31, Release the latch, and then take off the exit sensor

[F] Exit sensor (S31)

(1)Open the front upper cover and then pull out the saddle unit.

(2)Remove 1 screw, and then disconnect the connector and take off the sensor bracket.

Sensor bracket

Fig. 4-323

(3)Release the latch, and then take off the exit sensor.

Exit sensor

Fig. 4-324

[G] Saddle tray paper detection sensor (S32)

(1)Open the front upper cover and then pull out the saddle unit.

(2)Remove 1 screw, and then disconnect the connector and take off the sensor bracket.

Note:

When the sensor was installed, be sure to adjust the position of the sensor bracket.

P.4-26 "[A] Saddle unit"

Sensor bracket

Fig. 4-325

MJ-1103/1104	© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND INSTALLATION

4 - 114