Toshiba MJ-1104, MJ-1103 service manual Rollers Finisher section, Feeding roller, Board

4.4Rollers (Finisher section)

[A]Feeding roller

(1)Take off the right upper cover.

 P.4-7 "[J] Right upper cover"

(2) Take off the relay guide, feeding discharge brush and right cover.

 P.4-7 "[K] Relay guide / Feeding dis- charge brush / Right cover"

(3) Remove 4 screws of the FIN board bracket.

FIN board

(4)Release the harness out of 1 clamp, and then disconnect each connector of CN6 and CN8 on the IF board.

(5)Remove 2 screws of the IF board bracket.

Note:

When installing, screw the ground terminal together with the bracket.

Fig. 4-104

Clamp

I/F board

Fig. 4-105

(6)Remove 2 screws, and then take off the front bracket.

(7)Remove 2 screws, and then take off the rear bracket.

(8)Remove 2 screws, and then take off the junc- tion box upper transport guide.

Front bracket	Junction box upper
	transport guide
	Rear bracket
	Fig. 4-106

MJ-1103/1104	© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND INSTALLATION

4 - 38