Toshiba MJ-1104, MJ-1103 service manual Switchback unit

Notes:

When the saddle unit was installed, take off the saddle cover to check if the joint section of the pivot on the Finisher side and the plate on the saddle unit side is smooth.

1.Take off the saddle tray.  P.4-2 "[C] Saddle tray"

2.Open and close the saddle unit to check if the joint section of the pivot on the Fin- isher side and the plate on the saddle unit side is smooth, and also if the plate on the Finisher side contacts with the plate on the saddle unit side at 4 positions.

3.If not, loosen 2 screws of the Finisher side bracket and 1 screw on the saddle unit side to determine the proper posi- tions while the saddle unit is left closed.

Proper position
	4 sections of the
Finisher	plate are contacted
side plate
	Saddle unit
Adjustment required	side plate
	Any of 4 sections
Finisher	is not contacted
side plate	Saddle unit
	side plate

Fig. 4-76
Pivot
Finisher	Saddle unit
side plate
	side plate
Fig. 4-77

[B]Switchback unit

(1)Take off the saddle unit.  P.4-26 "[A] Saddle unit"

(2)Remove 4 screws, and then take off the upper safety cover.

Upper safty cover

Fig. 4-78

MJ-1103/1104	© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND INSTALLATION

4 - 28