Toshiba MJ-1103, MJ-1104 Job offset stack mode / Staple stack mode, Paper transport section

3.1.4Job offset stack mode / Staple stack mode

The job offset stack mode exits stacks of paper by slightly shifting them to the front and rear alternately, and the staple stack mode staples and exits stacks of paper. In both modes, paper transported from the feeding section is stacked on the buffer tray in the unit of 1 to 3 sheets.

The stacked paper is then moved to the finishing tray by the active drop mechanism. On the finishing tray the alignment of the stacks of paper and the job offsetting are performed.

In case a stack mode shifts to the staple stack mode after this, the stack of paper is stapled and exited to the movable tray.

[A] Paper transport section

At this stage, the buffer roller lift solenoid (SOL2) is turned ON to raise the buffer rollers and the buffer tray is moved by the buffer tray guide motor (M2) to the position where it matches with the paper width. The home position of the buffer tray is detected by the buffer tray home position sensor (S5).

Buffer tray guide motor

Buffer tray

home position sensor

Buffer roller lift solenoid

Buffer roller

Buffer tray

Fig. 3-10

3

© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved	MJ-1103/1104
	DESCRIPTION OF OPERATIONS

3 - 9