Vertex Standard FT-1000MP manual GrP1-cH, GrP2-cH, GrP3-cH, GrP4-cH, GrP5-cH, Quick-cH, Not Used

Menu Selection and Settings

INTRODUCTION

In earlier chapters, basic and advanced operation were covered to explain the various transceiver fea- tures. This chapter covers all of the menu selections entries and their settings used by the transceiver. These functions were described previously, but must be con- figured as desired using menu programming. Menu selections are shown as they appear in the display to assist you as you go along.

MENU SELECTIONS

Eighty-two transceiver settings are contained in pro- gramming menu (refer to the menu list shown on the opposite page).

rTo enter the “Menu” mode, press and hold in [FAST], then press [ENT].

rThe SUB VFO-B display will show the selection name, while the Main VFO display field shows the current setting for the selected menu item.

rRotating the VRF/MEM CH knob displays the vari- ous menu selections, whose numbers appear in the memory channel box.

rRotating the Main VFO knob, once you have se- lected a menu item, lets you choose between the various settings available for the displayed selec- tion. Some settings are merely an off/on switch, while others are variable tuning step sizes, time and frequency values, or mode choices.

0-1 GrP1-cH

Selects the number of default memory channels (from 1-99) available within Memory Group 1. If all 99 memory channels are enabled, Memory Group 2 is not configurable.

0-2 GrP2-cH

Selects the number of memory channels (from 1-

99)available within Memory Group 2 (if less than 99 memory channels are enabled in Memory Group 1). If all 99 memory channels are enabled, Memory Group 3 is not configurable.

0-3 GrP3-cH

Selects the number of memory channels available within Memory Group 3 (if Groups 1 and 2 are not con- figured for 99 channels total). If all 99 memory chan- nels are enabled, Memory Group 4 is not configurable.

0-4 GrP4-cH

Selects the number of memory channels available within Memory Group 4 if Groups 1, 2, and 3 are not configured for 99 channels total. If all 99 memory chan- nels are enabled, Memory Group 5 is not configurable.

0-5 GrP5-cH

Selects the number of memory channels available within memory Group 5 (to 99 total) if Groups 1, 2, 3, and 4 are not configured for 99 channels total.

Easy Recall Menu

Several menu selections can be accessed directly via two keystokes from the front panle:

[FAST] + [NB]	Menu 2-8	(nb)
[FAST] + [NOTCH]	Menu 2-9	(notch)
[FAST] + [VCC/MIC]	Menu 3-4 (briGHt)
[FAST] + [BK-IN]	Menu 7-5 (kyr-dLy)
[FAST] + RX-(SUB VFO-B)	Menu 8-7 (Sub-AGc)

0-6 quick-cH

Quick Memory Bank Channels - Allocates 1 to 5 memories for use with the instant-write “quick-memory” feature.

0-7 (Not Used)

page 98 MARK-V FT-1000MP Operating Manual