Vertex Standard FT-1000MP manual DVS-2 Controls

	Advanced Features
OPTIONAL DVS-2 DIGITAL VOICE RECORDER
OVERVIEW	DVS-2 Controls
The DVS-2is a digital voice recorder designed es-	(1), (2), & (3): PLAY, REC & TX LEDs
pecially for SSB, AM, and FM operation with newer
	These LEDs light or flash to indicate the status of
model Yaesu transceivers having a special jack for
	the DVS-2. The “PLAY” LED glows green when play-
connection of the DVS-2on the rear panel. It offers
	ing back stored data, the “REC” LED glows yellow when
two independent functions:
	recording, and the “TX” LED glows red when the DVS-
r Recording received signals for playback later in
	2 is keying the transmitter to play back over the air.
the loudspeaker or headphone;	Also, the “PLAY” and “REC” LEDs flash when waiting
r Recording signals, using the microphone,for	for you to make a memory selection (with a numbered
playback over the air (during transmission).	button).
Each mode uses its own memory, so both modes	(4) MESSAGE MODE Slide Switch
can be used to retain data at the same time. Operating
	This selects the mode for recording messages to
details are provided with the DVS-2, but a summary is
	be played back over the air: for either two 8-second
provided here.
	messages, or four 4-second messages. Changing your
INSTALLATION	selection does not erase previously stored messages,
	so you can use this switch to combine two pairs of 4-
Connect the DVS-2cable to the DVS-2jack on the
	second messages.
rear of the transceiver. You must also have a micro-
phone connected to the MIC jack on the front panel of	(5) MESSAGE NR Selection Buttons & LEDs
the transceiver to record your voice for transmissions.	These buttons select which message slot to record

via the microphone or play back over the air. The LED above each button glows red when a message has been stored in that slot. The [3] and [4] keys (and LEDs) are only functional when the MESSAGE MODE switch is set to the [4 x 4 SEC] position.

(6) MONI Button

After recording a message via the microphone, press this button (followed by a message number but- ton) to play back that message in the loudspeaker (in- stead of over the air).

(7) MEMO Button

Press this button (followed by a message number button) to record a message via the microphone.

(8) PLAY Button

After recording received signals, press this button to play them back in the transceiver’s loudspeaker.

(9) REC Button

Press this button to start the receiver recorder. The recorder will run continuously (recording an 16-second loop) until you press the [STOP] button.

(10) STOP Button

Press this button to stop any recording or playback operation.

MARK-V FT-1000MP Operating Manual page 81