Vertex Standard FT-1000MP manual Specifications, General, Transmitter, Receiver

SPECIFICATIONS

General

Rx Frequency Range:	100 kHz - 30 MHz
Tx Frequency Ranges:	160 - 10m (Amateur bands only)
Frequency Stability:	±0.5 ppm (after 1 min. @ 25 °C)
	±0.25 ppm (after 1 min. @ 25 °C, w/TCXO-6)
Operating Temperature Range:	–10 °C ~ +50 °C
Emission Modes:	LSB, USB, CW, FSK, AFSK, AM, FM
Frequency Steps:	0.625/1.25/2.5/5/10 Hz for SSB,CW, RTTY & Packet;
	100 Hz for AM and FM
Antenna Impedance:	50 Ohms, unbalanced
	16.6 - 150 Ohms, unbalanced (Tuner ON, TX only)
Power Consumption:		13.8 VDC	30 VDC
	Rx (no signal)	2.3 A	–
	Rx (signal)	2.7 A	–
	Tx (200 W)	2.2 A	14.5 A
Supply Voltage:	30 VDC and 13.8 VDC (FP-29)
Dimensions (WHD):	410 x 135 x 347 mm ( 16 x 5.3 x 13.7 inch)
Weight (approx.):	14 kg. (31 lbs)

Transmitter

Power Output:	Adjustable up to 200 watts (50 watts AM carrier),
	Class A mode (SSB): 75 watts maximum
Duty Cycle:	100% @ 100 watts, 50% @ 200 watts (FM & RTTY, 3-minute Tx)
Modulation Types:	SSB: J3E Balanced, AM: A3E Low-level (early stage),
	FM: F3E Variable reactance, AFSK: J1D, J2D Audio frequency shift keying
Maximum FM Deviation:	± 2.5 kHz
FSK Shift Frequencies:	170, 425, and 850 Hz
Packet Shift Frequencies:	200 and 1000 Hz
Harmonic Radiation:	Better than –60 dB (Typical)
SSB Carrier Suppression:	At least 40 dB below peak output
Undesired Sideband Suppression: At least 55 dB below peak output
Audio Response (SSB):	Not more than -6 dB from 400 to 2600 Hz
3rd-order IMD:	–31 dB @ 200 watts PEP, or better
	Class A mode: –50 dB @ 75 watts PEP (Typical)
Microphone Impedance:	500 to 600 Ohms

Receiver

Circuit Type:	Quad-conversion superheterodyne (triple conversion for FM)
Intermediate Frequencies:	Main Rx; 70.455 MHz/8.215 MHz/455 kHz, Sub Rx; 47.21 MHz/455 kHz
Sensitivity:	Modes		0.5 - 1.8 MHz		1.8 - 30 MHz
	SSB/CW (2.0 kHz)		2 µV		0.16 µV
	AM (6 kHz)		13 µV		2 µV
	FM		–		0.5 µV
	(with preamp on, IDBT on, SSB/CW/AM for 10 dB S/N, FM for 12 dB SINAD,
	0 dBµ = 1 µV)
Selectivity (–6/–60 dB):	Band Width	Modes		Minimum –6 dB BW		Maximum –60 dB BW
	2.4 kHz	all except FM		2.2 kHz		4.2 kHz
	2.0 kHz	all except FM		1.8 kHz		3.6 kHz
	500 Hz	CW/RTTY/Packet		500 Hz		1.8 kHz
	250 Hz	CW/RTTY/Packet		250 Hz		700 Hz
		AM (Wide)		4 kHz		14 kHz
		FM		8 kHz		19 kHz
IF Rejection (1.8 ~ 30 MHz):	80 dB or better (Main Rx), 60 dB or better (Sub Rx)
Image Rejection (1.8 ~ 30 MHz):	80 dB or better (Main), 50 dB or better (Sub)
Maximum Audio Output:	2.0 W into 4 Ohms with <10% THD
Audio Output Impedance:	4 to 8 Ohms

Specifications are subject to change, in the interest of technical improvement, without notice or obligation.

MARK-V FT-1000MP Operating Manual page 3