Menu Selection and Settings
|
|
Remote Control Function - Selects the active fea- ture for remote control operation.
Note - Remote control operation requires a
Keyer - Activates the contest keyer operation.
Function Keys - Emulate front panel Memory Con- trol keys.
If you wish to exercise remote control of the VL- 1000 Linear Amplifier from the
8-0 FASt-SEt
FAST Button Operation - Selects
Momentary - Press and hold to engage fast tuning.
Continuous - Toggle on/toggle off fast tuning.
8-1 Lock-SEL
LOCK Button Operation - Sets up the panel “Lock” mode:
Dial - Locks MAIN
Panel - Locks front panel buttons & keys (refer to drawing below).
Primary - locks front panel primary function keys (refer to drawing below).
Split Mode Operation - Select one of three split operating modes:
Normal - In this mode, pressing SUB
Auto - When the SUB
A=B - Same as Auto mode above; however, a pre- set frequency offset is applied to SUB
8-3 PA-cnt
Power Amplifier - Enable/Disable the Power Am- plifier. When you are using a transverter, select this menu to “PA off.”
8-4 FrontEnd
Receiver Front-End RF Amplifier - Selects the de-
sired receiver
Flat - A broadband amplifier with flat response.
Tuned - A separate tuned amplifier for the low and high bands.
8-5 Ant-SEL
Antenna Selection - Sets up the
AUTO - Antenna selections are automatically cop- ied along with other operating parameters during memory programming.
ON - Enables the front panel [ANT] switch.
OFF - Disables the front panel [ANT] switch (only
Panel Lock
When the Main VFO (A) [LOCK] button is pressed, all controls within the shaded area (except VRF and IDBT switches).
When the Sub VFO (B) [LOCK] button is pressed, only the SUB VFO Tuning knob.
Primary Lock
When the Main VFO (A) [LOCK] button is pressed, only the MAIN VFO Tuning knob.
When the Sub VFO (B) [LOCK] button is pressed, all controls within the shaded area.
page 104 |
|
