REMOVING THE IGNITOR MODULE & A BURNER IGNITOR
Sealed Burner Models
WARNING
Electrical Shock Hazard
Disconnect from electrical supply before servic- ing unit.
Failure to do so could result in death or electri- cal shock.
CAUTION: When you work on the gas range, be careful when handling the sheet metal parts. Sharp edges may be present, and you can cut yourself if you are not careful.
REMOVING THE IGNITOR MODULE
1.Pull the range away from the wall so that you can access the back.
2.Turn off the gas to the range and disconnect the power cord from the wall outlet.
3.From behind the range, remove the upper access cover.
4.Disconnect the wires from the old ignitor mod- ule (see the inset on the next page).
5.Remove the old ignitor module from the upper console and mount the new one in its place.
6.Connect the burner ignitor wires to the ignitor module terminals.
7.Reassemble the range.
REMOVING A BURNER IGNITOR
1.Pull the range away from the wall so that you can access the back.
2.Turn off the gas to the range and disconnect the power cord from the wall outlet.
3.Lift the maintop and prop it up (use the proce- dure on page
4.From behind the range remove the upper access cover.
5.Locate the wire coming from the defective burner ignitor and disconnect it from the igni- tor module.
6.Remove the defective burner ignitor from the maintop and install the new one in its place.
BURNER IGNITOR
MAINTOP
7.Route the wire coming from the new burner ignitor to the ignitor module and connect it to the terminal.
8.Reassemble the range.
