REMOVING THE IGNITOR MODULE & A BURNER IGNITOR
Conventional Burner Models
WARNING
Electrical Shock Hazard
Disconnect from electrical supply before servic- ing unit.
Failure to do so could result in death or electri- cal shock.
CAUTION: When you work on the gas range, be careful when handling the sheet metal parts. Sharp edges may be present, and you can cut yourself if you are not careful.
4.Lift the maintop until the support rods lock.
5.Remove the screw from the burner ignitor ground strap and unhook the strap from the burner bracket.
REMOVING THE IGNITOR MODULE
1.Pull the range away from the wall so that you can access the back.
2.Turn off the gas to the range and disconnect the power cord from the wall outlet.
3.From behind the range, remove the upper access cover.
4.Disconnect the wires from the old ignitor mod- ule (see the inset on the next page).
5.Remove the old ignitor module from the upper console and mount the new one in its place.
6.Connect the burner ignitor wires to the ignitor module terminals.
7.Reassemble the range.
TAB
GROUND STRAP
SNAP IGNITOR 
INTO SLOTS
SCREW
BURNER IGNITOR
BURNER
BRACKET
REMOVING A BURNER IGNITOR
1.Pull the range away from the wall so that you can access the back.
2.Turn off the gas to the range and disconnect the power cord from the wall outlet.
3.Remove the grates from the maintop.
6.Remove the ground strap from the old burner ignitor and snap the new ignitor into it.
7.Mount the burner ignitor and ground strap to the burner bracket with its mounting screw.
8.From behind the range, remove the upper access cover.
9.Locate and disconnect the old burner ignitor wire from the ignitor module.
10.Route the wire from the new burner ignitor, through the upper console to the ignitor mod- ule, and connect it to the terminal.
11.Reassemble the range.
