Cooking Products Service Manual
Original July, 1996 | 4321891 |
© 1996 Whirlpool Corporation | Page |
REMOVING THE INNER DOOR GLASS
WARNING
Electrical Shock Hazard
Disconnect from electrical supply before servic- ing unit.
Failure to do so could result in death or electri- cal shock.
CAUTION: When you work on the gas range, be careful when handling the sheet metal parts. Sharp edges may be present, and you can cut yourself if you are not careful.
1.Turn off the gas to the range and disconnect the power cord from the wall outlet.
2.Remove the oven door (see page
3.Remove the door handle, top trim, and outer door glass from the oven door (see page
4.Remove the
5.Remove one of the hinge assemblies from the oven door (see page
6.Lift the side of the insulation retainer and slide it out from under the remaining hinge assem- bly.
7.Fold back the door insulation, and remove the defective inner door glass from the metal frame.
8.If you are replacing the window seal, (the
9.Install the new inner door glass in the metal frame.
INNER | METAL |
DOOR | FRAME |
GLASS |
|
| DOOR |
| LINER |
10.Position the insulation around the metal frame.
11.Reinstall the insulation retainer in the door so the edge is under the hinge assembly.
12.Position the arm on the hinge assembly to be installed to the “broil stop” position, then mount it to the oven door with its two
13.Using the bottom of your shoe, press down on the hinge assembly arm, and insert the pin into the hole in the arm.
14.Mount the bottom trim to the oven door with its mounting screws.
15.Mount the outer door glass, top trim, and the door handle to the door.
16.Reinstall the oven door on the range.
