Electronic Oven Control 1
1.Press the BAKE keypad.
•The BAKE indicator will light.
•350 will appear in the display.
•The START? indicator will begin to flash after
2.Press the START/ENTER keypad.
•The PREHEAT or HEAT and ON indica- tors will appear. NOTE: The PREHEAT indicator light will not be displayed if the oven temperature is over 170˚F.
•The display will show the automatic count- down time
•The oven burner should light in 50- to 60- seconds (the delay is due to the time it takes for the gas valve to open and the gas to flow to the burner).
•After preheat, the PREHEAT indicator light will go out (Control A only).
•A
•The countdown timer will change to 350.
3.Open the storage drawer and check the flame coming from the burner bar. If the flame is noisy, or is blowing away from the bar, there is too much air during combustion. If the flame is soft and not high enough, there is not enough air. If either of these conditions occur, refer to step 6 on page
4.Press the OFF/CANCEL keypad.
Cooking Products Service Manual
Original July, 1996 | 4321891 |
© 1996 Whirlpool Corporation | Page |
Electronic Oven Control 2
1.Press the BAKE keypad.
•The BAKE indicator will light.
•350 will appear in the display.
•The START? indicator will begin to flash after
2.Press the START/ENTER keypad.
•PrE and 10:00 will appear.
•The HEAT and ON indicators will light.
•The oven burner should light in 50- to 60- seconds (the delay is due to the time it takes for the gas valve to open and the gas to flow to the burner).
•The oven is preheated when the time in the display counts down to 0:00.
•A
•PrE will change to 350.
3.Open the storage drawer and check the flame coming from the burner bar. If the flame is noisy, or is blowing away from the bar, there is too much air during combustion. If the flame is soft and not high enough, there is not enough air. If either of these conditions occur, refer to step 6 on page
4.Press the OFF/CANCEL keypad.
