Cooking Products Service Manual
Original July, 1996 | 4321891 |
© 1996 Whirlpool Corporation | Page |
6.Pull the range away from the wall so that you can access the back.
7.From behind the range, remove the upper and lower access covers and the lower heat shield.
IGNITOR MODULE |
| |
UPPER | UPPER | |
CONSOLE | ||
ACCESS COVER | ||
|
ROUTE WIRES
THROUGH 
UPPER CONSOLE
BURNER IGNITOR
(4)
LOWER
ACCESS
COVER
LOWER
HEAT
SHIELD
9.Slide the maintop to the right so that the left hinge pin is free of the hinge bracket, (see the inset), and then to the left so that the right hinge pin is free of its bracket, then set the maintop with the burner ignitors on top of the range. CAUTION: Be careful not to pull on the spark ignitor wires or you will pull them out of the ignitors.
MAINTOP
HINGE PIN
MOUNTING
SCREW 
UPPER
ACCESS
PANEL
INSERT HINGE
PIN IN BRACKET
HOLE IN UPPER
ACCESS PANEL
UPPER
CONSOLE
8.Unplug the burner ignitor wires from the igni- tor module, pull them through the back of the upper console to the front, and remove them from the maintop.
BURNER IGNITOR
MAINTOP
HINGE
BRACKET
HINGE PIN
MAINTOP
10.Remove the hinge pins from the old maintop and install them on the new one.
11.Install the new maintop and burner ignitors and reassemble the range.
