Cooking Products Service Manual
Original July, 1996 | 4321891 |
© 1996 Whirlpool Corporation | Page |
REMOVING A SEALED BURNER & A VENTURI
WARNING
Electrical Shock Hazard
Disconnect from electrical supply before servic- ing unit.
Failure to do so could result in death or electri- cal shock.
CAUTION: When you work on the gas range, be careful when handling the sheet metal parts. Sharp edges may be present, and you can cut yourself if you are not careful.
REMOVING A BURNER
1.Turn off the gas to the range and disconnect the power cord from the wall outlet.
2.Remove the grates and burner caps from the maintop.
3.Remove the screws from the defective burner.
SCREW
BURNER
MAINTOP
4.Lift the defective burner off the venturi and replace it with a new one, then reassemble the range.
REMOVING A VENTURI
1.Turn off the gas to the range and disconnect the power cord from the wall outlet.
2.Lift the maintop and prop it up (use the proce- dure on page
3.Lift the defective venturi from the burner box and replace it with a new one.
4.Lift the top of the coil around both venturi openings so they are even with the top.
5.Reassemble the range.
SLIDE COIL UP
TO TOP OF VENTURI
INSERT TAB
INTO SLOT
BURNER
BOX
BURNER
BURNER
IGNITOR
VENTURI
MAINTOP
