PRINT FORMAT COMMANDS
XEROX DOCUPRINT 180 LPS PDL REFERENCE 6- 75
PAPERSIZE
This parameter specifies the paper size to be used for pri nting the
job.
Syntax OUTPUT PAPERSIZE =
option(s)
Options Table 6-57 lists the parameter option(s) and definition(s).
If papersize is not specified, the LPS uses the system default paper
size specified during system generation.
Considerations When centimeters (CM) are used to specify paper size, the maximum
allowable value is 32.767 CM.
Paper size cannot be changed through DJDE on a page basis. Paper
sizes can be changed on a report basis, however.
Whether you use the keyword or the (x, y) m ethod for specifying
papersize in your JSL, you must use the same method in your forms
source library (FSL).
PAPERSIZE=B4 and PAPERSIZE=(10.12,1 4 . 3 3 ) produce identical
results in that they indicate long-edge feed, as opposed to short-edge
feed format. Refer to the “SEFFNT” section in the chapter “Specifying
input parameters,” for detailed information on short- and long-edge
feed.
B5 paper size is an option that requires that a retrofit kit be installed.
Include performance considerations when switching paper sizes
across pitch modes. Refer to “Using pitch and the TMODE
parameter effectively" section in this chapter.
Example OUTPUT PAPERSIZE=USLETTER,
FEED=MAIN,
DUPLEX=NO,
NUMBER=(1,1,80),
FORMAT=SMPPOE;
Table 6-58. PAPERSI ZE param e ter option(s) and definition(s)
Option(s) Definition(s)
A3 16.54 by 11.69 inches (297 by 420 mm)
A4 8.27 by 11.69 inches (287 by 270 mm)
B4 10.12 by 14.33 inches (257 by 364 mm)
B5 7.17 by 10.12 inches (178 by 254 mm)
USLEGAL 8.5 by 14 inches (216 by 356 mm)
USLETTER 8.5 by 11 inches (216 by 279 mm)
(

x

,

y

) a v ariable paper size, that is, a paper size that is not
one of the standard sizes.