SPECIFYING DYNAMIC JOB DESCRIPTOR ENTRIES (DJDES )
XEROX DOCUPRINT 180 LPS PDL REFERENCE 8- 67
TMODE
This parameter specifies process direction measurement for
determining default pitch mode.
Syntax TMODE =
option(s)
Options Table 8-57 lists the parameter option(s) and definition(s).
TOF
This parameter specifies the top-of-form line number. It takes effect
at the next record following a DJDE END. The value parameter is
defined the same as in the VFU command as defined in the chapter
"Print format commands."
Syntax TOF =
option(s)
Options Table 8-58 lists the parameter option(s) and definition(s).
Table 8-61. TMODE par am et er op tion(s) and definition(s)
Option(s) Definition(s)
(
width
[,
width
unit
]) This option has the following components:
•
width
The process direction measurement that
determines the default pitch mode.
•
width unit
Can be IN, CM, DOTS, or XDOTS. The
default is IN.
Width values can range from the 7-inch
equivalent to the 17-inch equivalent.
Table 8-62. TOF paramet er opt i on (s) and definition(s)
Option(s) Definition(s)
value
Specifies the number of lines from the top of the
output page to the first print line on the page (top
of form). The top-of-form specification is
independent of channel assignments. It should be
greater than or equal to 1 and less than or equal to
the smallest line number assigned to a channel.
The default is 1.