USING LOGICAL PROCESSING
7-36 XEROX DOCUPRINT 180 LPS PDL REFERENCE

Delimiter display

Display of the delimiter (performed only when DELIMITER=YES) is
dependent on the mode (Single/Multi) in which the job is run. Single
or multiple report mode is a selectable parameter on the offline
START command.
If the print job is run in single-report mode, the first delimiter of the
next report is displayed. This occurs after an end-of-report is
encountered. To begin the next single-report job, the operator must
key in another START command. If the report mode is Multi or the
system is online, the delimiter is not displayed.

Delimiter on accounting page

The user has the option to include part of the first record of a report
on the accounting page. This command is sele cted by coding the
ACCTINFO parameter, which is normally used to print part of t he first
delimiter.

Status display

The user has the parameter to display a subfield of the first record in
a report in response to the JOBS command or STATUS function key.
This command is selected by coding the HRPTNA or HJOBNO
parameter.
Note that HJOBNO is not an RSTACK parameter.

Online RSTACK usage

When using RSTACK online, consider the following:
•Detection of RSTACK criteria within a not yet recognized
banner page (RSTACK record occurs prior to BANNER criteria
line) results in subsequent incorrect report separation.
•Detection of RSTACK criteria in a recognized but incomplete
banner page (RSTACK record occurs after BANNER criteria
line) is ignored.
•Detection of RSTACK immediately following report separation
is ignored. This prevents null reports. If RSTACK is specified in
a selected JDE or JDL, that is, a JDE or JDL invoked in a
DJDE), the following restrictions to online systems apply:
— If RSTACK is not specified in the JD E or JDL of the START
command, the DELIMITER=NO parameter should be
specified in the selected JDE or JDL. Spe cification of
DELIMITER=YES is overridden.
— If RSTACK is specified in the JDE or JDL of the START
command, the DELIMITER parameter cannot be changed
in a selected JDE or JDL.
— If DELIMITER=YES is specified, a record that satisfies the
TEST criteria of a selected JDE or JDL results in an end of
report normally. However, it prints at the start of the