Yamaha RS7000 Installing the security bracket, Procedure

The Pattern Mode

12. Saving to Memory Card or Disk

RS7000 115

●About the Memory Cards

To handle Memory Cards with care:

• There are times when static electricity affects Memory Cards.

Before you handle Memory Cards, to reduce the possibility of

static electricity, touch the metal parts such as a door knob and

aluminum sash.

• Be sure to remove the Memory Card from the Memory Card

slot when it is not in use for a long time.

• Do not expose the Memory Card to direct sunlight, extremely

high or low temperatures, or excessive humidity, dust or liq-

uids.

• Do not place heavy objects on a Memory Card or bend or apply

pressure to the Memory Card in any way.

• Do not touch the metal part (gold) of the Memory Card or put

any metallic plate onto the metal part.

• Do not expose the Memory Card to magnetic ﬁelds, such as

those produced by televisions, speakers, motors, etc., since

magnetic ﬁelds can partially or completely erase data on the

Memory Card, rendering it unreadable.

• Do not attach anything other than the provided labels to a

Memory Card. Also make sure that labels are attached in the

proper location.

To protect your data (Write-protect):

To prevent inadvertent erasure of important data, stick the write-

protect seal (provided in the Memory Card package) onto the

designated area (within a circle) of the Memory Card.

Conversely speaking, to save data on the Memory Card, make

sure to remove the write-protect seal from the Card.

Do not reuse the seal that is peeled off.

Data Backup

For maximum data security Yamaha recommends that you keep

two copies of important data on separate Memory Cards. This

gives you a backup if one Memory Card is lost or damaged.

Installing the security bracket

You can install an optional security bracket to prevent theft of the

memory card. Install the security bracket as needed.

Procedure

1. Be sure that you have the following at hand before starting

the installation.

• Security bracket

• Phillips screwdriver: Magnetic-tipped screwdriver is rec-

ommended.

2. Remove the two screws at either side of the memory card

slot.

Use a Phillips screwdriver to remove the two screws from the

locations shown below.

3. Attach the security bracket.

Position the security bracket in the correct orientation (see

illustration below), and use the two screws you removed in

Step 2 to fasten it in place.

Write-protect seal

IMPORTANT

If the security bracket is installed, it will not be

possible to insert or remove the memory card.

Before you install the security bracket, check to

see whether the memory card is inserted in the

memory card slot.