Yamaha RS7000 23 Get Phrase, 24 Put Phrase

The Pattern Mode

14. Pattern & Phrase Editing — The Pattern Jobs

RS7000 147

4Split Measure

[Settings] 002 ~ source-phrase length

(in measures)

Specifies the measure at which the phrase will be split.

5Split Destination Style,

6Split Destination Phrase

[Settings] Style .............. OFF, 01 ~ 64

Phrase...........OFF, 001 ~ 256

Specify the destination style and phrase. After the Split

Phrase operation the section of the phrase before the speci-

fied split measure will remain in the source phrase, and the

section following the split measure will be moved to the split

destination phrase.

If the split destination style or section is OFF, the section

after the split measure will be erased.

Copies a segment of sequence-track data from a song into the

designated destination phrase.

1Source Song, 2 Source Track

[Settings] Song ..............01 ~ 20

Track............. 01 ~ 16

Specifies the copy source song and track.

3Source Range

[Settings] 001 ~ 999

Specifies the range of measures to be copied.

4Destination Phrase

[Settings] 001 ~ 256

Specifies the destination phrase.

5Copy Sample

When the checkbox is checked sample voices used by the

source track are copied to the destination style as local sam-

ple voices, and are assigned to destination phrase.

This parameter has no effect when no sample voice is used by

the source track.

Copies a selected user phrase into a speciﬁed area of a selected

song.

1Source Phrase

[Settings]

Phrase category US (User), Preset Phrase, see the

Appendix (Page 313) for information

on the phrase categories.

Phrase Number 001 ~ 256 (The available range may

change depending or the category.)

Specifies the source phrase.

23 Get Phrase

CAUTION

The job overwrites any data already existing in

the destination phrase.

1 2 3

45 [Knob 2] [Knob 3] [F4]

NOTE

•When there is no memory available in the des-

tination style for local sample voice data, “Too

Many Local sample Voices” will appear on the

display and the sample voice data will not be

copied. If this occurs, use Sample Job “02

Delete” (Page 246) to delete unused local

samples then try again.

•Undo/Redo (Page 134) can be used after a

sample voice copy operation, but will not

apply to the sample voice.

•When the “5. Copy Sample” box is checked

and the [F4] (DO!) button is pressed, the “Are

You Sure? Cancel [F2]/OK [F3]” confirmation

prompt will appear. [F3] will execute the Get

Phrase job.

24 Put Phrase

CAUTION

The job overwrites any data already existing in

the destination track.

5[Knob 2] [Knob 3] [F4]