Yamaha RS7000 - page 235

1. Recording Samples (Sampling)

RS7000 235

The Sampling Mode

2START Point ........................................................[Knob 2]

[Settings] 0 ~ End Point

Specifies the point in the sample that is to be the beginning of

the measure. When the Trim function is executed only the

portion of the sample between the START and END points

will remain. All other data will be deleted.

3END Point .............................................................[Knob 3]

[Settings] START Point ~ End of sample

Specifies the point in the sample that is to be the end of the

measure. When the Trim function is executed only the por-

tion of the sample between the START and END points will

remain. All other data will be deleted.

4STEP.........................................................................[Knob 4]

[Settings] ×1, ×10, ×100, ×1000, ×10000, ×100000

Sets the “magnification factor” to be used when [Knob 2] and

[Knob 3] are used to specify the START and END points.

Higher settings allow higher value changes.

5AUDITION.......................................................................[F2]

The sample will loop between the specified START and

END points while this button is held. This lets you hear pre-

cisely how the settings are affecting the sample.

6OK......................................................................................[F4]

Executes the normalize and trim operations.

The Slice page will appear automatically after execution.

7VOICE (Sample Voice Number)

The sample voice number to which the sample will be saved.

001 ~ 128 are local sample voices; C001 ~ C128 are common

sample voices.

The recorded sample is divided in to a number of “slices”, the

size of which is determined by the speciﬁed note length.

When the SLICE+SEQ sample type is selected, this page can be

selected from the Trim page by pressing [F4] (OK).

• The Initial Slice Display

•The Display After Slice Has Been Executed

1MEAS (Measure)................................................ [Knob 1]

[Settings] 1 ~ 8

Specifies the number of measures in the sample to be sliced.

When the slice operation is executed, sequence data corre-

sponding to the specified number of measures is created. The

sequence data is created from the beginning of the nearest

measure at the point at which sampling is started.

NOTE

The sample is played back from the START

point when the [AUDITION] button is pressed,

so use this capability to precisely locate the

desired start point. If the timing of the first

desired beat or sound is cut off or delayed when

the [AUDITION] button is pressed, adjust the

START point so that it is heard exactly on the

beat.

NOTE

Set the END point after setting then START

point. The sample will loop while the [AUDI-

TION] button is held, so you can hear precisely

if the END point is set at the appropriate loca-

tion.

Slice Page

NOTE

It is necessary to accurately adjust the length of

the sample before executing the slice operation.

Use the [F2] (AUDITION) button in the Trim

page to loop the sample and precisely set the

trim START and END points as required.

4 9 5

[Knob 2] [Knob 3][Knob 1] [F4]

[F2] [Knob 4][F1]

[Knob 2] [Knob 3][Knob 1]

[F4][F2]

[Knob 4]

[F1] [F3]