Fellowes Jupiter A3 manual HOT Lamination Steps, Supplied, Place pouch, sealed edge first, into

ENGLISH

HOT LAMINATION STEPS

1 2

1. Please connect the laminator to the	2. Switch laminator on with Power On /
socket using the separate power cable	Off button at back of machine.
supplied.

3

80 100 125

175

3.Press Stand-by button at left of front operating panel to switch laminator on.

4		5			6
80	100	125	80	100	125
175			175

4.Use navigation keys to select setting for the hot lamination pouch thickness (80-175 micron) you wish to laminate.

7

80 100 125

175

5.Confirm your selection by pressing “Enter” button in the middle of navigation keys. “Wait” LED () will begin flashing and laminator will take a few minutes to reach required temperature.

8

6.While laminator is warming up, please prepare item you wish to laminate. Place the item inside the pouch and center it against the sealed edge of the pouch. To prevent jamming, use a carrier sheet when item is smaller than the pouch.

9

7.“Wait” LED () will stop flashing and acoustic bleep signal will sound when machine is ready to laminate selected pouch thickness.

10

10.Before switching off laminator, feed empty cleaning/carrier sheet through machine to clean unit.

8.Place pouch, sealed edge first, into

laminator entry. Keep pouch straight and use the edge guide to centre it.

9.To prevent jamming, immediately remove laminated item from back of machine. Let item cool on flat surface for several seconds.

4