JVC GR-D350U manual Power, How To Attach The Lens Cap, How To Attach The Shoulder Strap, Getting

Connect the AC Adapter to the camcorder.

GETTING STARTED EN 11

How To Attach The Lens Cap

To protect the lens, attach the provided lens cap to the camcorder as shown in the illustration.

NOTE:

To confirm the lens cap is on correctly make sure the cap is flush to the camcorder.

Place here during shooting.

How To Attach The Shoulder Strap

Follow the illustration.

1 Thread the strap through the eyelet.

2 Fold it back and thread it through the strap guide and the buckle.

●To adjust the length of the strap, loosen and then tighten the strap in the buckle.

3 Slide the strap guide fully towards the eyelet.

	Buckle
Strap guide	2
	2

13

Eyelet

Power

This camcorder’s 2-way power supply system lets you choose the most appropriate source of power. Do not use provided power supply units with other equipment.

Charging The Battery Pack

Battery pack mount

	PUSH	STARTED
Battery pack	BATT.

	1		GETTING
Arrow	2	POWER/
		CHARGE

lamp

To DC connector

Power switch

AC Adapter

To AC outlet

1 Set the Power Switch to “OFF”.

2 With the arrow on the battery pack pointing downward, push the battery pack slightly against the battery pack mount 1.

3 Slide down the battery pack until it locks in place 2.

4

5 Plug the AC Adapter into an AC outlet. The POWER/CHARGE lamp on the camcorder blinks to indicate charging has started.

6 When the POWER/CHARGE lamp goes out, charging is finished. Unplug the AC Adapter from the AC outlet. Disconnect the AC Adapter from the camcorder.