GETTING STARTED EN 13
Using AC Power
Perform step 4 in “Charging The Battery Pack”.
NOTE:
The provided AC Adapter features automatic voltage selection in the AC range from 110 V to 240 V.
About Batteries
Operation Mode
To turn on the camcorder, set the Power Switch to any operation mode except “OFF” while pressing down the Lock Button located on the switch.
Lock
Button
DANGER! Do not attempt to take the batteries apart, or expose them to flame or excessive heat, as it may cause a fire or explosion. WARNING! Do not allow the battery or its terminals to come in contact with metals, as this can result in a short circuit and possibly start a fire.
To resume the original function of the accurate battery power indication
If the battery power indication differs from the actual operating time, fully charge the battery,
MENU AUTO |
POWER/
CHARGE lamp
GETTING STARTED
and then run it down. However this function may not turn back if the battery was used for a long period of time under extremely high/low temperature condition or charged too many times.
Choose the appropriate operation mode according to your preference using the Power Switch.
Power Switch Position
REC:
●Allow you to perform recording on the tape.
●Allows you to set various recording functions using the Menus. ( pg. 22)
OFF:
Allows you to switch off the camcorder.
PLAY:
●Allows you to play back a recording on the tape.
●Allows you to set various playback functions using the Menus. ( pg. 22)
Auto/Manual Mode
Press AUTO button repeatedly to switch to auto/ manual recording mode. When manual mode is selected, the indicator “M” appears on the LCD monitor.
Auto Mode A:
You can record using no special effects or manual adjustments.
Manual Mode M:
Manual recording is possible by setting various functions.