140 | 5 System troubleshooting |
Specific problems and corrective actions
The following contains specific problems that may arise during the use of your server. Possible solutions are listed for each problem.
Power indicator does not light.
Do the following:
•Make sure the power button on the front panel is turned on.
•Make sure the power cable is connected correctly.
•Make sure that the wall outlet has power. Test it by plugging another device.
•Remove all
•Make sure the memory board and memory modules comply with the system requirements.
•Make sure the memory modules have been populated according to the system requirements.
•Remove and reseat the memory board.
•Remove and reseat the memory modules.
•Make sure the processor complies with the system requirements.
•Make sure the processor is populated according to the system requirements.
•Remove and reseat the processor.
•Make sure the chassis standoffs are installed only below mounting holes. Misplaced standoffs may have contact to the pins on the bottom of the mainboard and cause a short.
Server powers on but turns off often with fault light.
Do the following:
•Make sure the memory boards are properly seated.
•Make sure the processor is properly seated.