Agilent Technologies G6600-90006 Unpack and Inspect the Instrument, Required Installation Tools

Step 2: Unpack and Inspect the Instrument

Before unpacking boxes, inspect them for signs of physical damage. If damage is observed, photographs should be taken in order to make a claim with the carrier should any equipment damage be found. Check contents of boxes against the shipping documents. Contact Agilent as soon as possible should a discrepancy be found.

Required Installation Tools

The following tools are recommended for installation of both the 355 SCD and

255 NCD:

•One adjustable wrench, with adjustment up to 1 inch (2.5 cm)

•One 1/4"-5/16" open-end wrench

•Two 3/8"-7/16" open-end wrenches

•Two 3/4"-9/16" open-end wrenches

•One 5/8" open-end wrench

•One 1/4" Nutdriver with hollow shaft (for FID restrictor)

•One Phillips head screwdriver

•One pair cotton gloves (for hand protection)

•One small flat-head screwdriver

Operation and Maintenance Manual 45