Step 4: Connect the Power Cord
Connect the pump power cord to the female socket on the back of the Detector (see Figure 17). The pump has an On/Off switch located on the electrical motor and this switch should be turned On. Do not connect to the AC power supply at this point in the installation procedure.
AIR INLET
RECORDER
OUTPUT
10V | EXHAUST |
1V
100mV
FUSE 250 VOLTS
10 AMPS
Voltage Label
VACUUM
PUMP
Figure 17 SCD (230 V Unit) Rear Panel Diagram
56 | Operation and Maintenance Manual |
