Installation, Overview | Agilent Technologies G6600-90006 specification

3 Installation

Overview 40
Step 1: Selecting a Location		41
Power Requirements	41
Figure 10. Drawing of the Detector with Dual Plasma Burner and Controller							42
Environmental Considerations			42
Combustion Gas Requirements			42
Step 2: Unpack and Inspect the Instrument					45
Required Installation Tools		45
Step 3: Set Up the Vacuum Pump			46
Installing the Edwards RV5 Pump Oil-Sealed Vacuum Pump 46
Figure 11. RV5 Oil-Sealed Vacuum Pump and Associated Traps (Front Side)							49
Figure 12. RV5 Oil-Sealed Vacuum Pump and Associated Traps (Back Side)							49
Figure 13. RV5 Oil- Sealed Vacuum Pump and Associated Traps (Top) 50
Figure 14. RV-5Oil-S ealed Vacuum Pump Exhaust Line 51
Installing the Welch Dry Piston Vacuum Pump						52
Figure 15. The Welch Dry Piston Pump					54
Figure 16. Oil Drain Kit with Ballast Control						54
Step 4: Connect the Power Cord			56
Figure 17. SCD Rear Panel Diagram				56
Step 5: Install the Dry Compressed Air or O2 Supply 57
Step 6: Install the Signal Output Cables				58
Standard Cable Connection		58
HP 3390 Series Integrator Cable Connection						58
HP 3396 Integrator Cable Connection					58
HP 5890 GC Analog Input Board			58
Agilent 6890 GC Analog Input Board					58
Step 7: Install the Dual Plasma Burner				59
Figure 18. Dimensions of GC Liner Cut-Outs						59
Step 8: Install the Dual Plasma Controller					60
Figure 19. Dual Plasma Controller Rear Panel						60
Step 9: Install Column Connections			61
Capillary Columns	61
Figure 20. Measuring Column Insertion					61

12	Operation and Maintenance Manual