Alcatel-Lucent manual OmniSwitch 6600-P24 Front Panel

OmniSwitch 6600 Family Chassis and Hardware Components OmniSwitch 6600-P24

Refer to the illustration below for more front panel information. For detailed LED descriptions, refer to page 2-18. For information on the chassis rear panel, refer to page 2-20.

Console Port			Gigabit Ethernet Uplink Module Slot
The OS6600-P24 front panel provides one RJ-
			The OS6600-P24 provides a dedicated slot for Gigabit Ethernet
45 port for console connections. Serial console
			uplink modules. This slot supports the following module types:
connections are used by network administrators
				• OS6600-GNI-C2—Provides two fixed 1000BaseT copper
for switch management. This female RJ-45 con-
nector provides a DCE console connection.				connections (uses two RJ-45 connectors). Supports distances
				up to 100 meters.
				• OS6600-GNI-U2—Provides two MiniGBIC bays that
				support hot-swappable 1000BASE-X MiniGBIC transceivers.
	TM	OmniSwitch 6600-P24
					EXPANSION	EXPANSION/STACKING
			25		26	2 7	2 8

					1	3	5	7	9	11	13	15	17	19	21	23
	CONSOLE
			SEL
OK1	PS1																LINK/ACT		LINK/ACT
																LINK/ACT		LINK/ACT
OK2	PS2	PRI	SEC	FAN	TEMP	4	6	8	10	12
					2						14	16	18	20	22	24

Status and Slot Indicator LEDs For information on the OS6600-P24’s status and slot indicator LEDs, refer to page 2-18.

Slot Selector Button

The slot selector button, located directly beneath the slot indicator LED, is used to manually assign slot numbers to switches in stacked configurations.

10/100 Ethernet Ports

The OS6600-P24 provides 24 Power over Ethernet (PoE) 10/100 Ethernet ports. These ports are twisted-pair and are individually configurable as 10BaseT or 100BaseTX. The ports use RJ-45 connectors. For information more information, refer to page 2-18.

Stacking or Uplink Module Slot

The OS6600-P24 provides an additional slot that can accommodate either a stacking mod- ule or a Gigabit Ethernet uplink module.

If you use a Gigabit Ethernet uplink module in this slot, the OS6600-P24 must be used as a stand-alone switch.

A stacking module must be installed in this slot if the switch is to be used in a stack. For detailed information on stacking switches, refer to Chapter 4, “Managing OmniSwitch 6600 Family Stacks.”

OmniSwitch 6600-P24 Front Panel

OmniSwitch 6600 Family Hardware Users Guide September 2006 page 2-9