![](/images/new-backgrounds/1202160/202160231x1.webp)
Setting Up a Stacked Configuration | Managing OmniSwitch 6600 Family Stacks |
|
|
|
|
Setting Up a Stacked Configuration
In order to set up a new stacked OmniSwitch 6600 Family configuration, you must complete the follow- ing steps, in the order they are listed:
1Individually assign slot numbers to all switches
2Attach all required stacking cables
3Boot the
For OmniSwitch 6600 Family switches, the term “slot” refers to the priority status of the switch within the stacked configuration. Slot numbers may range from 1 to 8. For detailed instructions on setting up a stack, refer to the sections below.
Assigning Slot Numbers
Before assigning slot numbers to switches in a stacked configuration, note the following important guidelines:
•The slot number is displayed by the slot indicator LED located on the left side of the chassis front panel (refer to “Status LEDs” on page
•Slot numbers do not need to be sequential. However, each switch in a stack must have a unique slot number. If duplicate slot numbers are encountered, an error will occur and the stack will be disabled.
•The top switch in the stack does not have to be designated as slot 1.
•By default, the
•After manually assigning the slot assignments for all switches and rebooting the stack, the primary role will be given to the switch with the lowest slot number. The secondary role will be given to the switch with the
•Changing the slot number of a chassis does not immediately change its management role (i.e., primary, secondary, or idle). You must reboot all the switches in the stack before these changes will take effect.
•Refer to the illustration on page
To assign a new slot number to one or more switches in a stack, follow the steps below:
1To change the slot number, gently insert a pointed item, such as the open, pointed end of a paper clip, into the small hole (labeled SEL) below the slot number LED on the switch’s front panel. The LED display will begin to flash. You can manually change the slot number as long as the LED continues to flash.
Note. The LED may also advance by one number when the SEL button is initially pressed.
page | OmniSwitch 6600 Family Hardware Users Guide September 2006 |