OmniSwitch 6600 Family Chassis and Hardware ComponentsBackup Power Supply
Viewing Power Supply Status for Stacked Configurations
When entering the show power command on the primary switch in a stacked configuration, you can either enter only the show power syntax or you can specify a specific slot number. For more information, refer to the examples below:
A Slot Number is Specified
If you specify a slot number after the command syntax, power supply information for only the correspond- ing switch displays. For example:
Power | Supplies in | chassis 2 |
PS | Operational Status | |
UP |
| |
NOT PRESENT | ||
In the example above, power supply status for the switch operating in slot 2 displays. No backup power supply is installed in the slot 2 chassis (or the backup power supply is powered off).
No Slot Number is Specified
If you do not enter a slot number, power supply information for all switches in the stack displays. For example:
Power | Supplies in | chassis 1 |
PS | Operational Status | |
UP |
| |
UP |
| |
Power | Supplies in chassis 2 | |
PS | Operational Status | |
UP |
| |
NOT PRESENT | ||
The example above shows the power supply status for a stack consisting of two switches. A backup power supply is present and running in the switch operating in slot 1; no backup power supply is installed in the switch operating in slot 2 (or the unit is powered off).
More Information on Stacked Configurations. For detailed information on stacked OmniSwitch 6600 Family switches, refer to Chapter 4, “Managing OmniSwitch 6600 Family Stacks.”
OmniSwitch 6600 Family Hardware Users Guide September 2006 | page |
