OmniSwitch 6600 Family Chassis and Hardware Components | Viewing Basic Chassis Information |
|
|
|
|
Viewing Basic Chassis Information
This section covers the following basic chassis information and monitoring commands:
show hardware info show module
show module long (and show ni) show chassis
show cmm
show session
Important Hardware Status Commands. Additional commands, used to view important hardware status information, are described earlier in this chapter:
•For information on viewing primary and backup power supply status, refer to page
•For information on viewing chassis temperature status, refer to page
•For information on viewing chassis fan status, refer to page
Hardware Information
To view basic hardware information about the switch, enter the show hardware info command at the CLI prompt. This command displays the following information:
• CPU type
• Flash and RAM memory information
• NVRAM battery status
• Jumper settings
• BootROM and Miniboot versions For example:
| |
CPU Type | : PowerPC 8245, |
Flash Manufacturer | : SanDisk |
Flash size | : 64094208 bytes (61 MB), |
RAM Manufacturer | : Kingston, |
RAM size | : 134217728 bytes (128 MB), |
NVRAM Battery OK | : YES, |
Interrupt Boot Jumper | : OFF, |
Force UART Defaults Jumper | : ON, |
Run Extended Memory Diags Jumper | : OFF, |
Spare Jumper | : ON, |
BootROM Version | : 5.1.5.115.R02, |
Backup Miniboot Version | : 5.1.5.115.R02, |
Default Miniboot Version | : 5.1.5.115.R02 |
OmniSwitch 6600 Family Hardware Users Guide September 2006 | page |
