OmniSwitch 6600 Family Chassis and Hardware Components | Viewing Basic Chassis Information |
|
|
|
|
Basic Primary Slot and Component Information
To view basic slot and component information for the base chassis only (i.e., no installed uplink or stack- ing modules), enter the show cmm command at the CLI prompt. This command displays the following information:
•Model name, also referred to as chassis type
•Chassis description
•Alcatel part number
•Hardware revision level
•Serial number
•Manufacture date(s)
•Current power and operational status
•Base chassis MAC address
•ASIC and firmware information
For example:
| |
CMM in slot 1 |
|
Model Name: | OS6648 , |
Description: | 48PT 10/100 Stack, |
Part Number: | |
Hardware Revision: | 210, |
Serial Number: | 2313283p, |
Manufacture Date: | FEB 05 2106€, |
Firmware Version: | N/A, |
Admin Status: | POWER ON, |
Operational Status: | UP, |
Power Consumption: | 40, |
Power Control Checksum: | 0x0, |
MAC Address: | 00:d0:95:12:ed:00, |
ASIC - Physical: |
|
For complete descriptions of the command output, refer to the OmniSwitch CLI Reference Guide.
Stacked Configurations. You can use the show cmm command to display information for all switches in a stack, or for a specified switch only. When the show cmm syntax is entered with no specified slot number, information for all switches displays. When a slot position is specified in the command line (e.g., 3), information displays for the corresponding switch only. For detailed information on stacked OmniSwitch 6600 Family switches, refer to Chapter 4, “Managing OmniSwitch 6600 Family Stacks.”
OmniSwitch 6600 Family Hardware Users Guide September 2006 | page |
