Alcatel-Lucent 6600 manual Installing Uplink and Stacking Modules

OmniSwitch 6600 Family Chassis and Hardware Components Installing Uplink and Stacking Modules

Installing Uplink and Stacking Modules

Before installing uplink or stacking modules, refer to the important guidelines listed below:

Note. These steps only apply to OmniSwitch 6624, 6600-U24, 6600-P24, and 6648 switches and not to OmniSwitch 6602-24 and 6602-48 switches.

•Stacking modules can only be installed in the far-right module slot. This slot is labeled EXPANSION/ STACKING and contains port positions 27 and 28 (OS6624/6600-U24) or 51 and 52 (OS6648).

•Do not attempt to install stacking modules at the EXPANSION slot at port positions 25 and 26 (OS6624/OS6600-U24) or 49 and 50 (OS6648).

•OS6600-GNI-C2 and OS6600-GNI-U2 uplink modules can be installed in either slot location. However, if you install a Gigabit Ethernet uplink module in the EXPANSION/STACKING slot, the switch must be used as a stand-alone unit.

•Port numbers are clearly marked on the OS6624, OS6600-U24, and OS6648 chassis front panels.

•Stacking modules cannot be hot swapped at any time.

Anti-Static Warning. Before handling any component, free yourself of static by wearing a grounding strap, or by grounding yourself properly. Static discharge can damage the switch and the uplink or stack- ing module.

1If there is a blank cover panel installed over the uplink or stacking module slot position, uninstall it by removing the two Phillips attachment screws. After the attachment screws have been removed, carefully pry the blank cover panel out and away from the chassis. Set the cover panel and attachment screws aside.

2Holding the uplink or stacking module by the front panel, carefully slide the circuit board into the card guide located in the chassis slot.

5 2

1

LINK/ACT

LINK/ACT

Inserting the Uplink or Stacking Module

OmniSwitch 6600 Family Hardware Users Guide September 2006 page 2-40