OmniSwitch 6600 Family Chassis and Hardware Components

Removing MiniGBICs

 

 

 

 

2Push the MiniGBIC into the slot until it is completely inserted and securely seated in the

OS6600-GNI-U2 module on OmniSwitch 6624, 6600-U24, 6600-P24, and 6648 or the built-in MiniGBIC ports on OmniSwitch 6602-24 and 6602-48 switches, as shown.

Installed MiniGBIC (OS6648 Shown)

Removing MiniGBICs

MiniGBICs modules can be hot swapped. You are not required to power off the switch before removing a MiniGBIC from the uplink module. To remove a MiniGBIC from the uplink module, follow the steps below:

Anti-Static Warning. Before handling any component, free yourself of static by wearing a grounding strap, or by grounding yourself properly. Static discharge can damage the MiniGBIC, as well as the switch and uplink module.

1On OmniSwitch 6624, 6600-U24, 6600-P24, and 6648 switches only, make sure that the captive screws on the OS6600-GNI-U2 are tightened and the module is securely installed in the chassis.

2There is a small removal handle at the front of the MiniGBIC transceiver. Carefully lift this handle; then, grasp the handle and carefully pull the MiniGBIC from the module.

3Store the MiniGBIC in a secure, static-free location. Placing the MiniGBIC in an anti-static bag is recommended.

OmniSwitch 6600 Family Hardware Users Guide September 2006

page 2-47

Page 71
Image 71
Alcatel-Lucent 6600 manual Removing MiniGBICs, Installed MiniGBIC OS6648 Shown