AMX G3 manual Baud, Device base

Figure106

PROTECTED SETUP page

Baud

Figure107

BAUD button

Note

Make sure to match the baud transmission rate for the external RS-232 device.

The BAUD button (Figure 107) sets the baud rate through a factory installed port at the rear of the Touch Panel. The baud rate is automatically set to 1,200 when you activate the MOUSE button. The RS-232 communication automatically defaults to the factory preset baud if you disable the MOUSE ON button.

∙BAUD Press the UP and DN buttons to set the data communication speed through a factory installed port on the Touch Panel. Available baud rates are 300, 600, 1200, 2400, 4800, 9600, 19.2, and 38.4.

Device base

Press the DEVICE BASE button to open the keypad (Figure 108) and set the base address for the Touch Panel. The base address range is 1–255.

68 Touch Panel Program Reference Color Active-Matrix LCD Touch Panels