AMX G3 manual AXU-CV/PB, AXU-CAPB, AXM-CV/PB, and AXM-CAPB

Figure198

IC connector sockets

G

CORP.199 50-0940

AXT-

EVE

PP

JP

ODD

Erasable programmable read only memory (EPROM) sockets for firmware

P J

JP

JP

Memory IC sockets

5.Carefully pry the ICs out of their socket connectors with a non-conducting flat- blade tool and insert the two upgrade firmware ICs into the sockets indicated in

Figure 198.

6.Rotate the circuit card back to the original position and place it in the CATP housing.

7.Place the bottom panel onto the touch panel and align the screw holes. Insert the four Phillips-head screws and tighten.

8.Plug all connectors back into the touch panel.

AXU-CV(/PB), AXU-CA(PB), AXM-CV(/PB), and AXM-CA(PB)

To install the firmware upgrade into the AXU-CV(/PB), AXU-CA(PB), AXM- CV(/PB), and AXM-CA(PB) touch panels:

1.Discharge the static electricity from your body by touching a grounded object.

2.Insert a flat-blade tool into the release slot on the CATP’s bezel and remove the engraved overlay.

3.Remove the four #6-32 mounting screws and carefully lean the CATP backward to expose the AXlink and RS-232 (optional) wiring.

4.Disconnect the AXlink and RS-232 connector and remove the CATP from the back box or equipment rack.

144 Firmware Upgrades Color Active Touch Panels