Note

The CATP must always be

installed with the release slot

located at the bottom.

Note

The BB-TP1 can also be mounted to wood or metal studs using the pre-drilled stud mounting holes.

3.Lay the AXU-CV(/PB) or AXU-CA(/PB) facedown onto a soft cloth and remove the four screws from the low-profile back box. Remove the back box and discard.

4.Place the BB-TP1 into the cutout and mark the threaded insert positions as shown in Figure 7.

5.Remove the BB-TP1 and drill eight holes as shown in Figure 6. Then, place #6- 32 threaded inserts into the four holes marked ‘B’ in the cutout dimensions illustration.

6.Disconnect the AXlink connector from the control system that supplies power and data to the AXU-CV(/PB) or AXU-CA(/PB). Then, disconnect the DB-9 connector from the external RS-232 device connected to the AXU-CV(/PB) or AXU-CA(/PB).

7.Remove one or more knockouts to accommodate the wiring as required.

8.Thread the incoming AXlink and RS-232 wiring through the BB-TP1 knockout.

9.Fasten the BB-TP1 to the solid surface with the mounting screws supplied with the enclosure.

10.Connect the AXlink and RS-232 wiring to the AXU-CV(/PB) or AXU-CA(/PB) circuit card. Refer to Wiring the Touch Panel for complete wiring information.

11.Fasten the AXU-CV(/PB) or AXU-CA(/PB) to the BB-TP1 with the #6-32 screws provided with the enclosure.

12.Insert the engraved overlay back into the bezel.

13.Connect the AXlink wiring to the AMX control system and RS-232 wiring to the external RS-232 device. The AXU-CV(/PB) or AXU-CA(/PB) will beep when you apply power.

Color Active-Matrix LCD Touch Panels

Installing Touch Panels

9

Page 17
Image 17
AMX G3 manual Color Active-Matrix LCD Touch Panels Installing Touch Panels