Note
The CATP must always be installed with the release slot located at the bottom.
8.Fasten the BB-TP1 to the plasterboard using the expansion screws supplied with the enclosure.
9.Connect the AXlink and RS-232 wiring to the AXU-CV(/PB) or AXU-CA(/PB) circuit card. Refer to Wiring the Touch Panel for complete wiring information.
10.Fasten the AXU-CV(/PB) or AXU-CA(/PB) to the BB-TP1 with the #6-32 screws supplied with the enclosure.
11.Insert the engraved overlay back into the bezel.
12.Connect the AXlink wiring to the AMX Central Controller and RS-232 wiring to the external RS-232 device. The AXU-CV(/PB) or AXU-CA(/PB) will beep when you apply power.
AXM-CV(/PB) or AXM-CA(/PB) (rack-mount)
Mount the AXM-CA(/PB) or AXM-CA(/PB) (Figure 10) rack-mount into an electronic equipment rack.
Figure10
AXM-CV(/PB) or AXM-
CA(/PB) Rack-Mount CATP
1.Thread the incoming AXlink and RS-232 (optional) wiring through the opening in the equipment rack.
2.Disconnect the AXlink connector from the AMX Central Controller that supplies power and data to the AXM-CV(/PB) or AXM-CA(/PB). Then, disconnect the DB-9 connector from the external RS-232 device connected to the AXU-CV(/PB) or AXM-CA(/PB).
3.Connect the AXlink and RS-232 wiring to the AXM-CV(/PB) circuit card. Refer to Wiring the Touch Panel for complete wiring information.
12 | Installing Touch Panels | Color Active-Matrix LCD Touch Panels |
