Figure9
AXU-CV(/PB) or AXU- CA(/PB), and BB-TP1 cutout dimensions
8.187
(FRAME)
7.80
.170 
7.46
.35 | | | | | | 7.10 | |
[8.9 MM] | | | [180.3 MM] |
| | | | | | | |
| | | | | | | |
.52
.125 [3.2 MM] MAX
3.22
2.94
[74.7 MM]
TWO .170 [4.3 MM] DIA HOLES PROVIDED ON
.125
1.70
4.25
4.50
(FRAME)
1.70
CUTOUT
2.Insert a flat head screwdriver into the release slot on the AXU-CV(/PB)’s or AXU-CA(/PB)’s bezel and remove the engraved overlay.
3.Lay the AXU-CV(/PB) or AXU-CA(/PB) facedown onto a soft cloth and remove the four screws from the low-profile back box. Remove the back box and discard.
4.Place the BB-TP1 into the cutout and mark the threaded insert positions as shown in Figure 9.
5.Remove the BB-TP1 and drill four #6-32 insert holes. Then, place a threaded insert into each hole.
6.Disconnect the AXlink connector from the AMX Central Controller that supplies power and data to the AXU-CV(/PB) or AXU-CA(/PB). Then, disconnect the DB-9 connector from the external RS-232 device connected to the AXU-CV(/PB) or AXU-CA(/PB).
7.Thread the incoming AXlink and RS-232 wiring through the BB-TP1 knockout.
Color Active-Matrix LCD Touch Panels | Installing Touch Panels | 11 |
