Anderson Manufacturing AV-9000 manual Cx Output, Select Setpoints

3.When this prompt is displayed with the AUTOMATIC/MANUAL choice, if the associated controller is configured for PID control and is in the manual mode, pressing the DOWN key will display the prompts below:

Note: The controller may have its manual actuator set to something other than CAxFn, and in this case the prompts below may be accessible even if the above section was AUTOMATIC.

Cx OUTPUT 1	visible if output 1 is proportional
MANUAL OUTPUT	nnn% value 0-100%, initially current value
Cx OUTPUT 2	visible if output 2 is proportional
MANUAL OUTPUT	nnn% value 0-100%, initially current value
These prompts allow the controller outputs to be manually changed. To change, press the			key, then the
key as required to desired output %, then press the		key. To exit, press the	ke y.

4.Following the top level CONTROL STATE ACCESS prompts, if setpoint changes are enabled via ENABLES & PASSWORDS and at least one setpoint has its PROMPT TEXT configured, the following prompt will appear:

SELECT

SETPOINTS

This prompt allows setpoint values to be changed. When displayed, pressing the key will display the following prompt:

t t t t t t t t t t t t t t t t t t t t default "SETPOINT x"

nnnnnnnn uuuuuu

This prompt is displayed for each setpoint which has its PROMPT TEXT configured, each prompt being accessed

via and keys. The "t t " field is the configured setpoint prompt text. The value for "nn" depends on the setpoint's upper and lower limits decimal position. The "uu" field is the configured setpoint units text.

Edition 3 5-2 Section 5

Rev G