Anderson Manufacturing AV-9000 manual Controller Number, Entering Controllers, 13-3

To utilize the CONTROL STATE ACCESS capability and select either AUTOMATIC or MANUAL control, proceed as follows:

From the “Normal Display”, depress the key, CONTROLLER 1 should be displayed on the upper display line (or what was configured for CA1 LINE 1 TEXT above) and A/M should be displayed on the lower display line (or what was configured for CA1 LINE 2 TEXT above). Depress the key directly below A/M and the lower display line should display AUTOMATIC MANUAL with the active selection blinking. To select Manual, depress the key directly below the MANUAL in the display.

13.1 ENTERING CONTROLLERS

From the Normal Display, press the key until CONFIGURATION is seen in the lower display line. If PASS- WORD appears in the lower display line, the correct “password” will need to be entered before access to CON- FIGURATION is allowed. If CONFIGURATION is not displayed, then Configuration has been disabled. Refer to Section 9, Enables and Passwords, for instructions to enable Configuration.

Note: A Controller, although configured, will not operate unless the corresponding PROCESS VARIABLE (PV) is properly configured.

With CONFIGURATION in the lower display line, press the key, then the key until CONTROLLERS appears in the lower display line.

1. Press the key to display CONTROLLER NUMBER.

CONTROLLER NUMBER

1

Selections

1-8

Press to change, then or to

desired controller number, then press the

to store into menory.

Section 13 13-3 Edition 3

Rev G