Step 8
Next, the display will show IVx DECIMAL POSITION, IVx RANGE LIMIT LOW, and IVx RANGE LIMIT HIGH. These will be used to calculate the engineering units range for volt/milliamp inputs for the Input being configured. For Thermocouple/RTD inputs, their values establish the expected range outside of which the instrument will consider the value "out of range". Select accordingly with the MOD, SCROLL, UP/DOWN arrows and ENTER.
Step 9
Depress the SCROLL key and skip over the rest of the Input Selections until the display shows IVx DISPLAY OPTION. Select IN BOTH MODES for this input.
Step 10
After depressing the ENTER key, depress the UP ARROW key to get back to the previous level of CONFIGURE.
Step 11
Depress the SCROLL key until RECORDERS is displayed in the lower line display.
Step 12
Depress the DOWN ARROW key to enter the Recorder Configuration section. Depress the SCROLL key and skip over the displays shown until the display shows Rx VALUE TO RECORD. Use the MOD and UP/DOWN keys to select IVx where X is the input channel being configured. Press ENTER to finalize this selection.
Step 13
Depress the SCROLL key and skip over the displays until the display shows Rx SPAN 1 LOW and enter the low end of the range of units to be recorded. In other words, what input value (in units) should represent the low end of chart. Input this value using the MOD, UP/DOWN arrows, SCROLL and ENTER as before.
Step 14
Repeat for Rx SPAN 1 HIGH, using the input value (in units) that should represent the high end of the chart.
Note: the recorder span should normally correspond to an even multiple of one hundred units (for example 0 to 200 or 30 to 130, not 0 to 130) so the scales are convenient to read.
Step 15
Depress the UP ARROW key 3 times to return to the Normal Display.
Step 16
Depress the CHART key until SELECT and CHART CONFIGURATION appears. Press the DOWN ARROW key to show CHART SIZE. Select the chart size being used. Press the UP ARROW key twice to return to the Normal Display.
Step 17
Depress the CHART key again until CHANGE CHART appears. the three retaining clips according to the size chart being used. Select YES with the LEFT ARROW key and then press ENTER.
Select YES. Install the chart. Be sure to adjust The display should show START NEW CHART.
After initializing the chart, the recorder should begin recording and displaying values for the Input Signal just configured.
Section 3 | Edition 3 |
