Anderson Manufacturing AV-9000 manual Test, 10-1

Section 10 - Test

Test describes all possible diagnostic tests built into the recorder.

From the Normal Display, depress the until TESTS appears in the lower display line. If PASSWORD appears in the lower display line, the correct "password" will need to be entered before access to Test is allowed. If TESTS is not displayed, then Test has been disabled. Refer to Section 9, Enables and Passwords, for instruc- tions to enable Test.

A list of available tests and their purpose are shown in Table 10-1.

TABLE 10-1 AVAILABLE TEST

Relays	Used to verify that all LEDs, Relays and/or Solid State Relay Drivers (SSRD) are
	working correctly.
Display	Used to verify the display is functional.
Keypad	Used to verify that all keys are functional.
LEDs	Used to verify that the functionality of the LEDs.
Chart Demonstration	Used to demonstrate chart capabilites.
	CAUTION: When this test is iniitated, any parameter values previously
	programmed in Chart Configuration and Recorders are replaced with the
	demonstration values.
A/D Reset Counter	Displays the number of times the A/D counter has been reset.
	FACTORY USE ONLY!
A/D Raw Hex Counts	Displays raw counts for inputs and grounds. FACTORY USE ONLY!
Calibrated Input Values	Displays calibrated input values for inputs and grounds. FACTORY USE ONLY!
mA Output	Used to verify the mA Output is functional.

Section 10 10-1 Edition 3

Rev G