Anderson Manufacturing AV-9000 manual For Inputs Board Position, 11-4

SIDE VIEW

	FOR INPUTS	1, 3, 5, 7	2, 4, 6, 8
	BOARD POSITION	JU13	JU14
Board 4	1
Board 3	2
Board 2	3

Board 1

4

When installing an Input Board for any reason, check the location (where this board is mounted), then verify the position of JU13 and/or JU14. TC WIDE or TC NARROW were selected, go to Step 5, if not, go to Step 6.

Step 5
Depress the	and the upper display line will show IVx CAL CJC OR TC and the lower display line will show
TC, or CJC. Select TC by depressing the ,		then the	until TC is blinking, then depress the
.
Step 6
Depress the	and the upper display line will show IVx PERFORM CAL and the lower display line will show

NO. Select YES to perform the calibration. Connect the appropriate one of the following inputs to the input

terminals of the input being calibrated:
100 ohm resistor	RTD Inputs
0.0 mA DC	Current Inputs
0.0 mV DC	TC or mV DC Inputs
0.0 V DC	Volt Inputs
Wait one minute, then depress the	key.
Step 7
Connect the appropriate one of the following inputs to the input terminals of the input being calibrated:
277 ohm resistor	RTD Inputs
20.00 mA DC	Current Inputs
25.00 mV DC	TC or 0/25 mV DC Inputs
100.00 mV DC	TC or 0/25+ mV DC Inputs
1.00 V DC	1 V DC Inputs
10.00 V DC	10 V DC Inputs
Wait one minute, then depress the	key.
Edition 3	11-4	Section 11

Rev G