Anderson Manufacturing AV-9000 manual Cx Remote SP Bias, None Used, 13-15

21.Press the to advance to the next parameter, REMOTE SETPOINT BIAS.

NOTE: Bias is applied to the remote setpoint before it is used, and to the output of the first controller in cascade mode, before it is used as the setpoint of the second controller. Bias is an offset added to the output. (Controller Output 1 + Bias ) = Controller 2 Setpoint.

Cx REMOTE SP BIAS

0

Selections

± 999999

(decimal position = 0)

Press the to change,then, to±9.9999 (decimal position = 4)

desired number, then press the .

22.Press the to advance to the next parameter, FEEDFORWARD SOURCE (only if FEEDFORWARD was selected as CONTROL TYPE).

Cx FEEDFORWARD SOURCE

NONE USED

NOTE: Whatever value is selected as the source of the setpoint, the decimal position and the units type follow what was configured in Process Variables.

Selections

NONE USED

IV1	IV2	IV3	IV4
IV5	IV6	IV7	IV8
PV1 PV2 PV3 PV4
DV1	DV2		DV3
DV4	DV5		DV6
DV7	DV8		DV9
DV10	DV11		DV12
CV1 CV2 CV3 CV4
CV5 CV6 CV7 CV8
CV9 CV10 CV11 CV12
TOTAL 1		TOTAL 2
TOTAL 3		TOTAL 4
SP1 SP2 SP3 SP4
SP5 SP6 SP7 SP8
OUTPUT 11		OUTPUT 12
OUTPUT 21		OUTPUT 22
OUTPUT 31		OUTPUT 32
OUTPUT 41		OUTPUT 42

SV1 SV2 SV3 SV4

Press the to change,then ,

, to desired choice, then press the .

Section 13 13-15 Edition 3

Rev G