Anderson Manufacturing AV-9000 manual Getting Started, Main Prompts

3.9 GETTING STARTED

Before attempting any configuration/programming, review Sections 3.3 Keypad Function; 3.4 Changing Param- eter Settings; 3.7 Display Details; 3.8 Chart Details; and Appendix C Reference Section.

Then, using the Flow Charts below, the Quick Start Procedure, page 3-14 and filled in the Software Reference/ Record Sheets, determine the prompts and parameters that will be required for proper operation of the instru- ment and begin the configuration and programming procedures as described in Section 4 Configuration; Section 5 Display Programming; Section 6 Chart Prompts, and if required, Section 7 Alarm Settings and Section 8 Action Time Settings. Section 9 contains procedures for Enabling/Disabling and entering Passwords.

Appendix D may be referred to for examples of how to program/configure some prompts and parameters.

MAIN PROMPTS

CHART

PROMPTS

CHART

PASSWORD

CHANGE	YES	START	CHART	TREND	CHART	CHART
CHART		CHART	ROTATE	COLLECT	SPEED	CONFIG

NO

DISPDISP

PROMPTSPASSWORD

CONTROLLER

STATE ACCESS*

SELECT

SETPOINTS*

SELECT

MANUAL VALUES*

DISP	DISP	SEQ DISP	OPER
MODE	FORMAT	DURATION	INPUT

SYSTEM	SYSTEM	ACT/TIME	ALARM
PROMPTS	PASSWORD	SETTINGS	SETTINGS
* CONTROLLER ONLY

TUNING

PARAMETERS*

ENABLES	CONFIG.	TEST	CAL	MODEL
PASSWORDS				REV

CONFIGURATION

CONFIG	INPUTS	CONSTANTS	CUSTOM	DERIVED	PROCESS
			CURVES	VARIABLES	VARIABLES

CONTROLLERS*

SETPOINTS* RECORDERS TOTALIZERS

TIMERS	LEDS	RELAYS	CURRENT	INSTRUMENT
			OUTPUTS	SETTINGS

DERIVED	OPERATOR	OPERATOR	CHART
ACTUATORS	INPUTS	MESSAGES	MESSAGES

CONTROL STATE

ACCESS*

SIMULATED VARIABLES

* CONTROLLER ONLY

Section 3 3-13 Edition 3

Rev G