Anderson Manufacturing AV-9000 manual R I V E D T U a T O R S E R a T O R, OIxx Copy / Initialize

4.Press the and the display advances to the next derived actuator to be programmed. Refer to the beginning of this section, page 4-80.

4.1.14 OPERATOR INPUTS

Operator Inputs are prompts programmed that allow these prompts to turn on or off actuators that control some other function within the instrument.

From the Normal Display, press the until CONFIGURATION is seen in the lower display line. If PASS- WORD appears in the lower display line, the correct "password" will need to be entered before access to Configu- ration is allowed. If CONFIGURATION is not displayed, then Configuration has been disabled. Refer to Section 9, Enables and Passwords, for instructions to enable Configuration.

With CONFIGURATION in the display, press the	, then the	until OPERATOR INPUTS appears in the
lower display line.

1. Press the to display OPERATOR INPUT.

OPERATOR INPUT

1

Press the	to change, then	to	Selections
			1 to 12

desired number, then press the .

2. Press the to advance to the next parameter, COPY/INITIALIZE.

OIxx COPY / INITIALIZE

NO

D E R I V E D

A C T U A T O R S

&

O P E R A T O R

I

Selections

Press the to change, then to

N P U

NO YES

desired choice, then press the .

T S

Section 4 4-85 Edition 3

Rev G