Anderson Manufacturing AV-9000 manual CA1 Line Text, Controller, Control State Access, 13-22

13.3 CONTROL STATE ACCESS

CONTROL STATE ACCESS provides a quick and convenient method for changing states, such as AUTO to

MANUAL or LOCAL to REMOTE setpoint. If configured, when the key is pressed, a two line prompt is displayed and the Function Keys, as configured, perform these change state requirements. The two line prompt which appears is fully configurable via the CONTROL STATE ACCESS section of CONFIGURATION.

From the Normal Display, press the key until CONFIGURATION is seen in the lower display line. If PASS- WORD appears in the lower display line, the correct “password” will need to be entered before access to CON- FIGURATION is allowed. If CONFIGURATION is not displayed, then Configuration has been disabled. Refer to Section 9, Enables and Passwords, for instructions to enable Configuration.

With CONFIGURATION in the lower display line, press the key, then the key until CONTROL STATE

ACCESS appears in the lower display line. Press the key to display CONTROL STATE ACCESS on the

upper display line.

1.Press the and LINE 1 TEXT appears in the upper display line and CONTROLLER x STATES appears in

the lower display line. This prompt defines the text that will appear in the upper display line when the key is pressed while in the Normal Display.

CA1 LINE TEXT

CONTROLLER x

Selections

TEXT

Refer to Section 3.4.2, Changing Text, for instructions .

NOTE: If the CONTROL STATE ACCESS is not being used for Controller 1, it is suggested that this prompt be blank.

Edition 3 13-22 Section 13

Rev G