CONSTANTS - System Prompts - Configuration - Page
Prompt section containing parameters used as fixed values which are typically used for scaling constants in Derived Variables.
CONTINUOUS (ACTUATION) - System Prompts - Configuration - Operator Inputs - Page
A choice for the parameter ACTUATION STYLE which specifies that the actuator associated with an Operator Input will remain in the selected state continuously, rather than momentarily. See MOMENTARY.
CONTINUOUS (DISPLAY MODE) - Display Prompts - Page
A choice for the parameter DISPLAY MODE which specifies that the instrument will continuously display a single step of the Display Sequence, and will not automatically advance. The UP or DOWN keys can be used to step backward or forward through the list or series of displays.
CONTINUOUS (TOTAL) - System Prompts - Configuration - Totalizers - Page
A choice for the parameter TOTALIZER TYPE which specifies that the total counts to 999,999,999 and then rolls- over. The corresponding actuator (TOTAL 1 through TOTAL 4) is true whenever the total is equal to or greater than the TOTALIZER PRESET value. The RESET ACTUATOR resets the total to zero.
COUNT DOWN PRESET - System Prompts - Configuration - Totalizers - Page
A choice for the parameter TOTALIZER TYPE which specifies that the total counts down to zero from a preset value. The corresponding actuator (TOTAL 1 through TOTAL 4) is true whenever the total is equal to zero. The RESET ACTUATOR resets the total to the TOTALIZER PRESET value.
COUNT TO PRESET - System Prompts - Configuration - Totalizers - Page
A choice for the parameter TOTALIZER TYPE which specifies that the total counts to or just above the preset value and stops. The corresponding actuator (TOTAL 1 through TOTAL 4) is true whenever the total is equal to or greater than the TOTALIZER PRESET. The RESET ACTUATOR resets the total to zero.
CURRENT OUTPUT RANGE - System Prompts - Configuration - Current Outputs - Page
CURRENT OUTPUTS - System Prompts - Configuration - Page
Prompt section containing parameters which configure the sources and ranges for the current
CUSTOM CURVES - System Prompts - Configuration - Page
Prompt section containing parameters which specify the characteristics of custom curves. Each of 4 curves can have up to 20 point pairs. The curve is applied by selecting a CUSTOM CURVE choice as a Derived Variable function. The curves can be used to perform
CUTOFF TYPE - System Prompts - Configuration - Inputs
Parameter that specifies the optional cutoff or lower boundary condition to be established and applied to an IV (Input Value).
CUTOFF VALUE - System Prompts - Configuration - Inputs
Parameter that specifies the value to be used in conjunction with CUTOFF TYPE.
CYCLIC - System Prompts - Configuration - Operator Messages - Page
One of the choices for DISPLAY MODE that specifies that the Operator Messages will appear “cyclically”. In Continuous Display Mode, “cyclically” means that the display will alternate between the normal selected value or message display and the highest priority Operator Message. Message priority is in order of message number, with Operator Message 1 being the highest priority. The UP and DOWN keys can be used to change the selected value or message, as they normally would. In Sequential Display Mode, “cyclically” means that the display will sequence through all normal value displays and then all active Operator Messages.
Edition 3 | Appendix C |
Rev G
