Brocade Communications Systems 804 manual Diag, Operands Sfpshow, Tempshow, Beacon

diag B

diag

Lists the non-destructive group of diagnostic commands. The port can be identified using the adapter index, the port index, the port name, or the port world wide name.

NOTE

The sfpshow and beacon diag commands are not supported on the Brocade 804 mezzanine card.

Synopsis bcu diag --sfpshow<port_id> bcu diag --tempshow[ad_id]

bcu diag --beacon<port_id> {on off} [<secs>]

bcu diag --pciloopback<port_id> <-p <pattern> [-c <frame_count>]

bcu diag --loopback<port_id> [-t <loopback_type>] [-s <speed>] [-c <frame_count>] [-p <pattern>]

bcu diag --memtest<port_id>

bcu diag --queuetest<port_id> [-q <queue_num>]

Description Displays the group of diagnostic commands that are non-destructive and indicates when the adapter is running at a normal operation state.

NOTE

You must disable the port prior to executing the loopback test. You must disable the adapter prior to executing the memtest.

Operands	--sfpshow	Monitors the attributes of the SFP. This is an online diagnostic test.
		Note: A notification occurs for any parameter that is not within the configured
		power, temperature, voltage, and current specification or policy.
	port_id	Specifies the ID of the port on which you want to monitor the SFP attributes.
	--tempshow	Reads the adapter’s temperature sensor registers of the adapter. This is an
		online diagnostic test.
	ad_id	Specifies the ID of the adapter for which you want to display temperature
		sensor registers.
	--beacon	Controls the port and link end-to-end beaconing. This is an online diagnostic
		test.
	port_id	Specifies the ID of the port for which you want to beacon.
	on off	Turns end-to-end beaconing on or off.
	secs	Displays the beacon time duration in seconds. Beaconing is automatically
		turned off after the specified duration. If the duration is set to 0, beaconing
		continues until it is explicitly turned off.

Brocade Adapters Administrator’s Guide	137
53-1001583-01